Motor plugs into Standard 110V Outlet, shipped with 6 feet of wire and a plug, special order longer wire. (Do not shorten power cables to less than 42" because the antenna is in the cable and the motor will not work if the antenna is cut.)
Motor is inside shade roller, on right or left your choice, only power cord sticks out.
Each shade is controlled by a hand held remote or wireless wall switch.
Control single or multiple shades by pressing a button, shade can be set to stop at a mid point or run to the limit stops
Motors use about 1.5 amps, remote range 100 ft.
Standard with all motorized units is a pre-programmed remote control, single or multi channel. Motorized shades are ready to plug into a grounded outlet or they can be hardwired to a junction box.
To hardwire to a junction box, install a shut off switch for each motor or disconnect each motor from the power source to program.
110V PLUG IN MOTOR WITH RADIO REMOTE
